Single channel video signal lightning protection device OK - SV/BNC

Single channel video signal lightning protection device video surge protector lightning protection device video OK - SV/BNC

Product introduction:

   OK - SV/BNC / 2 video signal lightning protection device is mainly used for coaxial cable transmission line cable transmission system,CCTV video surveillance system equipment (such as hard disk video recorders, matrix, optical transceiver, cameras) of surge protection.Can prevent the above all kinds of equipment such as being struck by lightning or industrial noise induced over-voltage, over-current and other instantaneous surge voltage, permanent damage to the system or equipment or instantaneous interruption of the hazards.

Function characteristics:

1, the flow capacity of 10 ka mu s (8/20).

2, multi-stage lightning protection, rapid response, the insertion loss.

3, the core electronic components all use well-known brands.

4, series installation, simple and convenient installation.

Technical parameters:

Lightning protection device installation instructions:

1, this series of video signal lightning protection device can be installed in LPZ0-1 area or series installed directly on the protected equipment (or system) front end, when installation from the protected equipment (or system) the closer the better.

2, lightning protection device are connected to the signal input (IN) and output (OUT) are connected to the protected equipment, can not meet the

3, PE line must be of lightning and the lightning protection system to strict equipotential connection, otherwise will affect the work performance.

4, the product does not need special maintenance, as far as possible when installed by end into the equipment; When work system malfunction suspected lightning protection device, can be removed after the lightning protection device to check again, if back to normal after reduction to the use of state, should replace the lightning protection device.

5 the shortest line connection, lightning protection grounding as possible. The grounding lightning protection device adopts the terminal grounding method, with lightning protection grounding wire must be connected to ground (or protected equipment shell). A signal shielding wire can be directly to the earthing terminal.

6, the lightning protection device installed under the condition of no more than requirement is not need long-term maintenance, just system routine maintenance; Problems such as in use process, signal transmission, signal transfer back to normal after for lightning protection device, explain lightning protection device has been damaged, need to repair or replacement.